The Eldi tool did not work very well, but Var made one just like it that did. It would pop them right off at the top of the nipple; must have been the tightness, or slight dimensional differences, or just better overall quality of the Var tool. Trying to grind spokes down invariably means slipping off the spoke a few times and putting gouges in the rim, at least in my experience.
Steve Benson Charlotte, NC
|--------+------------------------------------> | | Harvey M Sachs | | | <sachs@erols.com> | | | Sent by: | | | classicrendezvous-admin@bi| | | kelist.org | | | | | | | | | 12/12/2000 12:21 PM | | | | |--------+------------------------------------> >--------------------------------------------------------------------------------------------------------------------------------------------------| | | | To: Sheldon Brown <CaptBike@sheldonbrown.com>, classicrendezvous@bikelist.org | | cc: | | Subject: Re: [CR]Help: the ELDI Whatzit... | >--------------------------------------------------------------------------------------------------------------------------------------------------|
I suspect Sheldon "old man" Brown is right, will try to purchase and check. This is a bit ironic since (a) last week I posted on my way of grinding them down, using a cut-off wheel, and (b) following Dale Brown's suggestion on that, I've acquired a second bench grinder, which now has a cutoff wheel for that job.
thanks, all who had ideas
harvey "thick" sachs
At 10:44 AM 12/12/2000 -0500, Sheldon Brown wrote:
>Harvey M Sachs wrote:
>
>>Trying to figure out the use of an ELDI tool I found recently. Closely
>>resembles the classic ELDI or VAR pliers-type chassis, two iron beam
>>about 7" - 8" long, with pivot bolt located to give high leverage/small
>>jaw opening. Flat-wound spring between the handles to hold it open. The
>>Jaws are the puzzling part:
>>
>>1) don't open but maybe a cm or so (1/2")
>>2) Working ends are replacable little cylinders, with concave faces and
>>fairly sharp lips.
>>3) When closed, the faces are offset front-to-back from each other
>>instead of lining up. Buck-tooth by a mm or two.
>
>It's a spoke-snipper-offer. Back in the bad old days of simple channel
>rims, the spokes would sometimes protrude past the ends of the
>nipples. They would need to be filed or ground down so as to not puncture
>the tube.
>
>This ELDI tool is s'posed to have the longer jaw rest against the edge of
>the nipple head, and the shorter jaw shears off the protruding end of the
>spoke. Never worked too well in my experience, I used to prefer a small
>grinding wheel in a hand-held electric drill.
>
>Sheldon "Maybe Harvey's Not As Old As I Thought" Brown
>Newtonville, Massachusetts
>+-------------------------------------------------------+
>| I'm the Webmaster for Revels, Inc. |
>| If you live near Boston; Hanover, New Hampshire; |
>| Houston; Media, Pennsylvania; Minneapolis/St. Paul; |
>| New York City; Oakland, California; Washington, DC; |
>| Tacoma, Washington; or Portland, Oregon... |
>| Come see The Christmas Revels! |
>| http://www.revels.org |
>+-------------------------------------------------------+
> Harris Cyclery, West Newton, Massachusetts
>Phone 617-244-9772, 617-244-1040, FAX 617-244-1041
> http://harriscyclery.com
> Hard-to-find parts shipped Worldwide
> http://captainbike.com
> Useful articles about bicycles and cycling
> http://sheldonbrown.com