Are you sure the hole is >4mm deep? I had the same prob w/ a water bottle boss which I assumed pierced the frame tubing (it did not I finally figured out w/ only mild destruction)
tom witkop rockville, md
On Sun, 17 Dec 2000 01:02:25 +1300 "Jon Bridges" <jon@icetv.co.nz>
writes:
> On the Campy downtube braze-on shifters, the little bolt that screws
> into the braze-on on the right hand side, won't screw in all the
> way. It is about 4mms shy I reckon of where it should be. I've
> tried CRC in the hole, and scratching down the hole with a paper
> clip and safety pin (to try and clear the thread), but I can't seem
> to get it to go any further. Any ideas?
>
> Jon Bridges, Auckland, NZ. (66F @ 1am)
>
>
> _______________________________________________
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit:
http://dl.www.juno.com/