Re: [CR]Overtightening cranks

(Example: Framebuilders:Brian Baylis)

From: "feldmans" <feldmanbike@yahoo.com>
To: <Wornoutguy@aol.com>, <classicrendezvous@bikelist.org>
References: <11e.6d0b9a3.2915650f@aol.com>
Subject: Re: [CR]Overtightening cranks
Date: Sat, 3 Nov 2001 11:30:31 -0800


Vintage advice, from the 70's weight-weenie phase; to install crankarms with steel bolts and washers, torque to spec, remove steel hardware and replace
with aluminum.
ER


----- Original Message -----
From: Wornoutguy@aol.com
To: classicrendezvous@bikelist.org
Sent: Saturday, November 03, 2001 7:19 AM
Subject: [CR]Overtightening cranks



> I attempted to take a crank off of a friends bike who had used a pet Gorilla
> to install his crank arms. Lucky he had steel crank bolts because it took
> my 1/2 inch drive breaker bar and a two foot extension of pipe to get the
> bolts free. I almost rounded one. It had not cracked the crank arms but
> they had gone way to far on the spindle. When I attempted to put them back
> on at the correct torque they worked. A few weeks later he came to me with a
> new set of arms. It was just as difficult to take them off the second time -
> the taper was destroyed even with correct torque they were history. This is
> not as vintage but on my bikes I use aluminum crank bolts. I tighten with a
> good sturdy steel bolt and my torque wrench. Then I remove the bolts. I
> use red lock tight on my aluminum bolts (one reason they are in a Ti spindle)
> and I just snug them in. I have not had to retighten them ever. (they had
> aluminum crank bolts in the 70s so this is kind of vintage). When chuck
> stated that automotive fasteners are replaced that is due to high torque -
> imagine the torque load on a head bolt compared to a bike crank -- imagine
> how much fun you would have replacing a headgasket (TWICE) and putting in all
> new bolts because you scrimped on head bolts and used the old ones in your
> car- How many of us replace the wheel studs every time we take a wheel off of
> our cars. I reuse aluminum fasteners on my bikes and have for years never
> had a failure. I can't imagine a steel crank bolt breaking because of reuse.
> Sam D.
>
>
> _______________________________________________
>

_________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com