Re: [CR]Pulling rim joints togeather. Tying spokes


Example: Racing

Date: Wed, 15 May 2002 07:12:35 -0700
From: Bill Bryant <Bill_Bryant@prodigy.net>
To: Mark Poore <rauler47@hotmail.com>
Cc: classicrendezvous@bikelist.org
Subject: Re: [CR]Pulling rim joints togeather. Tying spokes
References: <F41juh3liW9ueBp7rZe000009e1@hotmail.com>


Mark Poore wrote:
> I have never heard of lacing to cross the spokes over the seam, but it
> sounds interesting and maybe a 4 cross would provide a better angle for that
> theory. Any thoughts from the wheel builders on that one?
>

Though not crucial to wheelbuilding success, this generally helps pressed rim joints in a small way. But the difference in pulling tension between three or four cross isn't too much and shouldn't determine your choice as to which pattern to use. More important than this minor factor is to orient the spokes to create the most space around the tire valve with parallel spokes so as to give the best room for tire inflation with a hand pump. That will be of greater usefulness, IMHO.

Bill Bryant
Santa Cruz, CA