Re: [CR] tapers and grease (drifting of aluminum on steel)

(Example: Books)

Date: Sun, 04 Aug 2002 20:56:15 -0700
From: "Chuck Schmidt" <chuckschmidt@earthlink.net>
To: classicrendezvous@bikelist.org
Subject: Re: [CR] tapers and grease (drifting of aluminum on steel)
References: <B9728CD3.310A%ko_te_jebe@mac.com> <001601c23c31$9a7c59e0$41b1b2d1@apgmaa>


Andrew Gillis wrote:
>
> All CRs:
>
> I found in the past that greasing the threads of a steel steering tube
> allowed for an aluminum headset to drift and lose its setting faster. This
> was not a problem with a steel headset installed on a steel steering tube.
>
> So, I've eliminated my problem with an aluminum headset drifting because I
> use OIL to lubricate the steering tube threads. My favorite is Phil Wood
> ("Uncle Phil") but any thicker oil will probably do.
>
> Similarly, I've lightly oiled the BB axle tapers without bad effects. One
> drop, rubbed around all four sides, just enough to dampen the surface of the
> axle, has been fine for me.
>
> The drifting of aluminum on steel, when using grease, has been consistent. I
> once ruined a NR hub when the greased setscrew of a rear NR derailleur
> loosened up and put the chain in the spokes (circa 1977).
> After a rear wheel rebuild, the setscrew stayed put when I used oil.
>
> I hate learning the hard way!
>
> Andrew Gillis (Long Beach, CA)

In over 25 years of using grease on threads I've never experienced any of the problems you have had. Never had an aluminum headset "drift" on a steerer tube (that's what the locknut is for) and never had a Nuovo Record or any other derailleur lose its adjustment. Campagnolo's derailleurs have used springs to keep the screws secure in their place and I have never had one back out.

Oil or grease keeps the exposed BB axle from rusting ;)

Chuck Schmidt SoPas, SoCal

.