Re: [CR]campagnolo 2 bolt seat post design/removal

From: "Mike Waite" <mrwaite@btinternet.com>
To: "kevin gregor" <kevin@audiobahn.com>, <classicrendezvous@bikelist.org>
References: <000301c29a21$f954aeb0$2e60c118@jackaharala>
Subject: Re: [CR]campagnolo 2 bolt seat post design/removal
Date: Mon, 2 Dec 2002 17:02:14 -0000

I've just changed saddles on a Campag 2 bolt seatpin this morning.

Loosen both bolts the same amount, until you can turn the top clip of the saddle clamp through 90 degrees. Then move the saddle forward, releasing it through the wider rails at the rear of the saddle

Hope that helps

Mike Waite
Amersham Bucks UK
mrwaite@btinternet.com

----- Original Message -----
From: kevin gregor
To: classicrendezvous@bikelist.org
Sent: Monday, December 02, 2002 4:43 PM
Subject: [CR]campagnolo 2 bolt seat post design/removal

> Perhaps I'm approaching this the wrong way, but I'm a little confused
> about removing a saddle from a 2 bolt campagnolo seat post. Both of the
> bolts seem to be on the top of the clamp, and virtually inaccessible by
> my wrench. A new wrench may work, but what's up with this design?