Re: [CR]Campagnolo Shift Levers with Cable Guides

(Example: Framebuilders:Masi)

From: <>
Date: Sat, 25 Jan 2003 21:14:55 EST
Subject: Re: [CR]Campagnolo Shift Levers with Cable Guides

In a message dated 1/25/2003 8:43:17 PM Eastern Standard Time, writes:

my additions<> Larry Black
> Down tube clip

<or bz bosses>
> R.H./L.H. Plate

<sleel on clamp-on, with or without cable stop> alloy for bz-on
> Metal washer

<Built-in/pressed on steel for clamp on aluminum or delrin for bz-on>
> Control lever

<more concave side outward>
> Metal washer
> <earlier mod. thin pressure washer, 'double-D' hole in center, followed by chromed pressure backing plate>

<later models, delrin 'double-D' pressure plate followed by conical (cone-side out)backing pressure washer, followed by teensy lackwasher>

> Adjusting Screw
> <with foldable wing ring>

> Is this the correct set-up!!!!
> Nick Zatezalo
> Atlanta,Ga
> That's it. Too far to go downstairs for part numbers off my catalogue attached to my fake-wood service center cabninet, a relic in itself

Larry Black
Mt airy, Md.