Re: [CR]Pino Hub skewers

(Example: Framebuilders:Chris Pauley)

Date: Wed, 17 Dec 2003 21:25:22 -0500
From: "Joe Bender-Zanoni" <joebz@optonline.net>
Subject: Re: [CR]Pino Hub skewers
To: "James M. Kerr" <jim-kerr@comcast.net>, classicrendezvous@bikelist.org
References: <NPEDLCGAOOGCMLKPMGOGKEJOCKAA.jim-kerr@comcast.net>


Just like they say.

Pino Moroni skewars from the Detroit master. Yes, TI shafts.

And they work very well too.

Joe Bender-Zanoni
Great Notch, NJ


----- Original Message -----
From: "James M. Kerr"
To: classicrendezvous@bikelist.org
Sent: Wednesday, December 17, 2003 8:34 PM
Subject: [CR]Pino Hub skewers



> I just found a pair of old hub skewers in my tool box. They have to be from
> the 70's since all that stuff was acquired no later than 1979.
>
> The clamp end has a black curved arm and the round end is marked as follows:
>
> PINO
> INT. LTD.
> DETROIT
>
> The PINO and the DETROIT are curved to fit the 13mm diameter end cap.
>
> The rods look like ti to me. Strange wound springs (not tight).
>
> The adjusting cap has two nylon screws at 180 degrees.
>
> Can identify these skewers.
>
> Thanks,
>
> Jim Kerr
> New Haven, CT