Re: [CR]Parting up a BIKE OF DEATH

(Example: Framebuilders:Masi)

From: "Thomas R. Adams, Jr." <kctommy@msn.com>
To: classicrendezvous@bikelist.org
Subject: Re: [CR]Parting up a BIKE OF DEATH
Date: Thu, 30 Sep 2004 13:33:58 +0000


I'd spec Rigida 1320 rims instead of the Fiamme's. No need to mess with tubulars to get rims that will fail you under all conditions! And I was much lighter back then, too! Build it with a Maillard Helicomatic rear hub for lots of spoke breakage, and use the Modolo carbon fiber DT shift levers for even more fracturing fun.

Tom Adams, Shrewsbury NJ.


>From: Joe Bender-Zanoni <joebz@optonline.net>
>To: Donald Gillies <gillies@cs.ubc.ca>,classicrendezvous@bikelist.org
>Subject: Re: [CR]Parting up a BIKE OF DEATH
>Date: Thu, 30 Sep 2004 06:36:07 -0400
>
>Jacobs Cool Gear Saddle
>
>Hi-E Time Trial Front Hub with a really tight QR skewar
>
>
>----- Original Message -----
>From: "Donald Gillies" <gillies@cs.ubc.ca>
>To: <classicrendezvous@bikelist.org>
>Sent: Wednesday, September 29, 2004 10:34 PM
>Subject: [CR]Parting up a BIKE OF DEATH
>
>
> > Dear CR Listmembers,
> >
> > I am parting up a BIKE OF DEATH. Could you please help me,
> > with component suggestions, for the mostly deadly bicycle
> > parts of the 1960's - 1980's ?? No idea too bad will be
> > rejected. Here is where I've gotten so far :
> >
> > Fork: Lambert
> > Stem: AVA drilled
> > Seatpost: Weyless
> > Brakes: Dia Compe w/Lever Extensions
> > Rims: Fiamme Ergal
> >
> > How should I finish up this BIKE OF DEATH ?? Suggestions ??
> >
> > - Don Gillies
> > San Diego, CA