Re: [CR]Park 16mm wrench - Deciding vote?


Example: History:Ted Ernst

Date: Fri, 3 Dec 2004 13:10:10 -0800 (PST)
From: Jerome & Elizabeth Moos <jerrymoos@sbcglobal.net>
Subject: Re: [CR]Park 16mm wrench - Deciding vote?
To: John Everett <jeverett3@earthlink.net>, classicrendezvous@bikelist.org
In-Reply-To: <41B07F46.25130.AFE9D71@localhost>


That Zeus arm (I have several like it) has the 22.0mm Campy extractor thread. But I don't know if that is to the the base or the crest of the thread. The thread depth is probably about 1mm, so which way the thread diameter is measured would determine whether a 21.8mm OD socket would fit or not. You probably have to try it and see.

Regards,

Jerry Moos Houston, TX

John Everett <jeverett3@earthlink.net> wrote: On 3 Dec 2004 at 16:00, gpvb1@comcast.net wrote:
> Does anyone have an UNMODIFIED 16mm socket that works on a Zeus crank
> arm, and if so, what brand & drive size is it so I can get one? The
> wall would have to be incredibly thin, so personally, I doubt any
> unmodified socket will work. Greg Parker Dexter, Michigan

If the ID of the recess in a Zeus crank is indeed 22mm, as suggested by John Thompson, then the Craftsman 44311, with an OD of 21.8mm should work. Perhaps I should bring mine along next time I'm in the AA area (I get there often) and we could give it a try. :-)

Or you could put the bike in your car and haul it over to the Sears at Briarwood and try one out. ;-)

John Everett - Aurora, Illinois

jeverett3@earthlink.net (John V. Everett)