Re: [CR]Ignorant Record hub question(s)

(Example: Framebuilders:Brian Baylis)

Date: Tue, 27 Sep 2005 06:52:29 -0700
From: "Steven Willis" <>
Subject: Re: [CR]Ignorant Record hub question(s)
To: "Doug Van Cleve" <>, "Classic Rendezvous" <>
References: <>

You are headed in the right direction. The inside is all the same you can cut down the axle or just pick up a 5 speed axle I have them if you need them and the smaller spacers too. Have fun. Steven Steven Willis 1778 East Second Street Scotch Plains NJ 07076 908-322-3330

----- Original Message -----
From: Doug Van Cleve
To: Classic Rendezvous
Sent: Monday, September 26, 2005 3:08 PM
Subject: [CR]Ignorant Record hub question(s)

> Howdy folks.
> I know about the pre-CPSC flat skewers, but did anything else much change
> on Record hubs? I am trying to gather parts that at least look right for a
> 1975 frameset. Is there anything that makes it difficult to remove a
> spacer
> on a 126mm spaced rear wheel/hub to use in a 120mm frame (I assume that is
> what I have)? Are high flange hubs more valuable than low flange? Thanks
> :^
> )
> Doug Van Cleve
> Chandler, AZ