[CR]Adjusting dropout screws to the limit--Example


Example: Production Builders:Peugeot

From: LouDeeter@aol.com
Date: Mon, 29 May 2006 17:57:54 EDT
To: classicrendezvous@bikelist.org
Subject: [CR]Adjusting dropout screws to the limit--Example

jerrymoos@sbcglobal.net writes:

If someone were obsessive about constantly adjusting the stops, he would eventually wind up with the wheel at the front of the DOs.

_http://cgi.ebay.com/Vintage-Masi-Gran-Criterium-Calif-Campagnolo-Cinelli_W0QQ itemZ7245044873QQcategoryZ98084QQrdZ1QQcmdZViewItem_ (http://cgi.ebay.com/Vintage-Masi-Gran-Criterium-Calif-Campagnolo-Cinelli_W0QQitemZ7245044873QQcategory Z98084QQrdZ1QQcmdZViewItem)

This Masi, see above ebay link, (I had to work Masi into this discussion) belongs to Gianni Pergolizzi. Looking at adjustor screw and the rear axle, I can conclude that 1) if the Campagnolo dropout is similar then adjusting forward to the limit will not result with the wheel in front of the DO and 2) that Gianni is obsessive. Lou Deeter, Orlando FL