Re: [CR]track bottom bracket question

(Example: Production Builders:Pogliaghi)

From: <DTSHIFTER@aol.com>
Date: Sun, 25 Jun 2006 14:03:49 EDT
Subject: Re: [CR]track bottom bracket question
To: hayesbikes@gmail.com, classicrendezvous@bikelist.org


In a message dated 6/25/06 1:53:44 PM, hayesbikes@gmail.com writes:

<< The spindle has engraved 110 on it, which corresponds to its length. I assume that this is the original bottom bracket, but when I attempt to put a Campagnolo track crankset on it, there is not enough room for the crank to clear the bottom bracket lug.>>

Tom,

The 110 on the spindle refers to the rear spacing and that spindle is 104/105mm in length (depending upon bottom bracket shell width - so check that as well). The spindle length for 120mm rear spacing was 109mm.

Regards,

Chuck Brooks
Malta, NY