[CR]Fixed! was bent dropout screws

(Example: Framebuilding:Restoration)

From: "Eric Elman" <tr4play@cox.net>
To: <classicrendezvous@bikelist.org>
References: <MONKEYFOODhxvzSoBJH000041cf@monkeyfood.nt.phred.org> <44AF43C4.6040003@sonic.net>
Subject: [CR]Fixed! was bent dropout screws
Date: Sat, 8 Jul 2006 11:07:13 -0400
reply-type=response

To all 12 friends that responded on and off list - thank you.

This was far simpler than I expected which was particularly nice as this has been a frustrating week for me otherwise. I follwed the simple method of screwing the adjusters in as far as they could go; then used large snips to cut off just prior to the bend; then used a jewlers file to clean the thread at the cut, then unscrewed them out. Simple, no fuss, mo muss. I'm reassembling the Sachs now and am hoping to ride her today. If not, then the Raysport today and the Sachs tomorrow.

Here's a link to the Sachs:

http://ebay.com/<blah

Thanks list.

Eric Elman
Somers, CT USA


----- Original Message -----
From: Jay Sexton
To: classicrendezvous@bikelist.org
Sent: Saturday, July 08, 2006 1:33 AM
Subject: [CR]bent dropout screws



> Hi Eric,
>
> I have a couple of suggestions.
> Depending on how bad the screws are bent, take a plastic headed mallet and
> gently tap the screws until they straighten out. Don't use pliers. If
> the screws are loose in the d.o. turn the screw, tap, turn, tap until the
> screw looks straight, then back out. I have saved many a adjuster screw
> using this method.
>
> If you don't want to save the screws, or don't need to, use a fine toothed
> hack saw blade or end nippers to cut or saw the screw off. Close, but not
> totally flush with the d.o. Then file the end of the screw to get rid of
> any burr or deformity, otherwise as you unscrew it from the d.o. it could
> damage the thread, which you want to avoid.
>
> Take your time, use some oil on the threads, and good luck!
>
> Jay Sexton
> Sebastopol, CA
>
>
>
> Help! I've got a frame (an otherwise very nice Sachs that I want to ride
> tomorrow) that has both dropout adjuster screws bent fairly severely.
> What is the best way to remove them without damaging the threaded holes
> that they reside in? Both are bent sufficently so that they cannot be
> straightened enough to still unscrew in their normal manner.
>>
>> I could have sworn this was discussed recently but my various searches
>> through the archives yielded nothing.
>>
>> Thanks in advance,
>>
>> Eric Elman
>> Somers, CT USA