Re: [CR]Rechromed Forks - Prep?


Example: Events

From: "Peter Weigle" <jpweigle@sbcglobal.net>
To: "Classicrendezvous@Bikelist.Org" <classicrendezvous@bikelist.org>
References: <002b01c61f7b$aa5c4510$6400a8c0@valuedinsignia>
Subject: Re: [CR]Rechromed Forks - Prep?
Date: Sun, 22 Jan 2006 14:12:57 -0500
reply-type=original

Rodney, My advice would be to blow them out with compressed air until all traces of the water are gone. If you want to do a low "bake" feel free, but low, don't over do it. Then apply Frame Saver per instruction sheet on can. Should work well! Hope this helps.
Peter Weigle
Lyme, Ct.


----- Original Message -----
From: "Rodney Handsfield"
To:
Sent: Sunday, January 22, 2006 12:45 PM
Subject: [CR]Rechromed Forks - Prep?



>I just picked up the newly rechromedforks for my Colnago Super. I
> flushed out the plating reagent with water until the return was clear.
> What is the group consensus on baking, etc. prior to treating with
> Frame-Saver? thanks in advance, Rod Handsfield, Wichita - 20 miles
> (cold) on a Teledyne Titan