Not to highjack, but is anyone still making 144 rings? (My last 151 crank was stolen on a track bike, and I still have too many 151 rings left).
Mitch Harris little rock canyon, Utah
On 12/12/06, joebz@optonline.net <joebz@optonline.net> wrote:
>
> Keep in mind that a machinist can make oval slots in a 144 ring quite
> easily so they fit on a 151 crank. It would be best to take a stack so that
> the set up time is spread over a few. Blaine Velo Sports 763- 712-0312 near
> the NSC Velodrome north of Minneapolis had someone lined up to do this but I
> am talking about 10 years ago.
>
> Mike Kone had some rings made up a while ago. I'll let him tell the story
> if he cares to.
>
> Jim Merz made rings in the 1970s and I think they were over $50 so a price
> of $100 plus makes sense.
>
> Highpath Engineering could make them for $150 or so.
> http://www.highpath.co.uk/
>
> Joe Bender-Zanoni
> Great Notch, NJ
>
>
> ----- Original Message -----
> From: Peter Brueggeman
> Date: Tuesday, December 12, 2006 12:38 pm
> Subject: [CR]interested in 44-tooth 151 BCD 3/32" (and possibly 1/8")
> reproduction chainrings????
> To: classicrendezvous@bikelist.org
>
> > CR, I'm looking into having some 44-tooth 151 BCD 3/32" (and
> > possibly 1/8")
> > reproduction chainrings made. What do folks think is a
> > reasonable retail
> > price for one, and would you buy one if it were available at
> > that price?
> > Feel free to respond offline to me.
> >
> > Thanks for your interest, Peter
> > ============================================
> > Peter Brueggeman
> > San Diego California USA
> > pbrueggeman(AT)ucsd.edu