Re: [CR]Sstronglight Extractor Thread.

(Example: Component Manufacturers:Chater-Lea)

In-Reply-To: <449.28ddad.3194f363@aol.com>
References: <449.28ddad.3194f363@aol.com>
From: "Steve Leitgen" <sleitgen@charter.net>
Subject: Re: [CR]Sstronglight Extractor Thread.
Date: Thu, 11 May 2006 15:46:17 -0500
To: Likestadraw@aol.com
cc: classicrendezvous@bikelist.org

At the risk of repeating myself Sheldon Brown has them at Harris Cyclery (Google them). The $50 or so is far cheaper than having one custom made. The TA one is too small and I started to pull out the threads on my 105. The one I got from Sheldon pulled the crank slicker than snot.

Steve Leitgen La Crosse, Wi

On May 11, 2006, at 3:06 PM, Likestadraw@aol.com wrote:
> Reproducing a mating thread is not a difficult job. Knowing the
> pitch and
> pitch diameter is the easy way to do it. Not knowing those
> dimensions is not an
> issue either. The pitch can be measured and determined by the
> machinist and
> is most likely the same as other size pullers The pitch diameter
> can be
> gauged by feel as the thread is single point cut. Anyway it was
> just and offer to
> help, no offence to anyone.
>
> Bill McCune
> Parker Colorado USA