Re: [CR]Re: Stronglight extractor thread


Example: Bike Shops

Date: Thu, 11 May 2006 15:09:35 -0700 (PDT)
From: "Ted E. Baer" <wickedsky@sbcglobal.net>
Subject: Re: [CR]Re: Stronglight extractor thread
To: classicrendezvous@bikelist.org
In-Reply-To: <321.3be63a3.3194edd8@aol.com>


I was taught that Stronglight removal tools were 23.35mm (actually 23.35mm x 1.) Wanted to make sure so I checked an old "United Bicycle Tools" catalog that I have laying around dated spring/summer 1997. Flip to page 16. Third item down or the far right says: STRONGLIGHT CRANK EXTRACTOR: "Professional quality tool fits pre-1982 Stronglight cranks which had 23.35mm diameter threading. Use of any other tool in these cranks is likely to strip the threads. Professional quality. VR-22/2 $21.00."

Too HOT in Palo Alto, CA
Theodore Edward Baer


--- StuartMX4@aol.com wrote:


> Have I missed something? Without knowing the pitch,

\r?\n> nobody who doesn't have

\r?\n> a Stronglight extractor at hand will be able to

\r?\n> recognise the thread. You need

\r?\n> OD (which is not going to be as precise as two

\r?\n> places of decimals) and the

\r?\n> pitch either in metric or TPI.

\r?\n>

\r?\n> Stuart Tallack in West Sussex