[CR]FS: (maybe) Old Raleigh Headset Wrenches

(Example: Humor)

Date: Mon, 23 Jul 2007 15:08:02 -0500
To: Jerome & Elizabeth Moos <jerrymoos@sbcglobal.net>
From: "Mark Stonich" <bikesmith@earthlink.net>
In-Reply-To: <229917.47422.qm@web82205.mail.mud.yahoo.com>
References: <954702dd0707230905w56422358s389ae1764ca60526@mail.gmail.com>
cc: "classicrendezvous@bikelist.org" <classicrendezvous@bikelist.org>
Subject: [CR]FS: (maybe) Old Raleigh Headset Wrenches

At 7/23/2007 09:24 AM -0700, Jerome & Elizabeth Moos wrote:
>So anyone know a source for Whitworth wrenches that would fit a TDC
>HS? The locknut is smaller than 32mm, maybe close to 30 mm, though
>I doubt a 30 mm wrench will work. The adjustable cup is just a bit
>too big for a 40 mm wrench. I recently bought a Whitworth wrench
>set at a reasonable price, but it only goes up the 9/16 W, which
>isn't large enough.

I made one from flat stock years ago. But just the other day I was at a distributor who has a huge box of the old Raleigh Multi tools. http://bikesmithdesign.com/SA/RaleighWrenches.jpg

If there is enough interest, at $5 ea., I could pick up a few. S&H would be $6 for Priority mail. 1st class would be $4 but I would wait till I had several buyers, then make a trip to the PO for enough stamps.

Or, I'd ship them free with purchase of a cotter press or Raleigh fixed cup tool.

Mark Stonich;
     BikeSmith Design & Fabrication
       5349 Elliot Ave S. - Minneapolis. MN 55417
            Ph. (612) 824-2372 http://bikesmithdesign.com
                        http://mnhpva.org