Re: [CR]Campagnolo Nuovo Tipo hub advice and parts needed

(Example: Framebuilders:Rene Herse)

Date: Sun, 22 Jun 2008 13:10:06 -0500
From: "John Wood" <braxton72@gmail.com>
To: "Jay S" <jvs@sonic.net>
Subject: Re: [CR]Campagnolo Nuovo Tipo hub advice and parts needed
In-Reply-To: <485DF30E.4010202@sonic.net>
References: <MONKEYFOODcIeVuqvMY000012e8@monkeyfood.nt.phred.org>
cc: classicrendezvous@bikelist.org

Yes, I have experienced same. I luckily have an old set of Zeus cone wrenches that are narrow enough to fit. And by old, I mean they looked quite old when I acquired them in the late 70's. I have no recollection of where I got them. All others I've tried have been too fat. Not sure how helpful this bit of information will be, but there are wrenches out there that will work.

-- John Wood Washington Island, Wisconsin, USA

On Sun, Jun 22, 2008 at 1:37 AM, Jay S <jvs@sonic.net> wrote:
> Tonight I was attempting to adjust the cones on my Nuovo Tipo front hub,
> and the hub wrenches would not fit. The space between the grease cup/seal
> and the locknut was so narrow that a wrench would not get in there. Tried
> both Park and Campy cone wrenches. Anyone else encounter this problem?
> Archives did not cough up the answer. Hope one of you will!
>
> Also, I am in need of a set of the correct lock nuts for a rear Nuovo Tipo
> hub. Anyone have a set to sell, or direct me to a source?
>
> Thanks very much.
>
> Jay Sexton
> Sebastopol, CA