Re: [CR]REG pump holder on e-bay

(Example: Framebuilders:Alex Singer)

From: <>
Date: Mon, 23 Jun 2008 13:24:28 EDT
Subject: Re: [CR]REG pump holder on e-bay

Jay, As Aldo showed, it is for the old Silca or REG pump heads. Here is a pic of how I made it work on my c.1955 Torpado. Not sure if I did it right or not. Note however, that getting a correct and snug fit was very difficult. If I set the clips far enough apart to get the compressed pump in, then it would fit loosely and rattle around. If I moved the clips a bit closer together, then the compressed pump would not fit in between them. I was forced to add some padding in the deep pocket of the lower, REG clip, which now holds the pump more firmly in place. Not GREAT, but very workable.

Ciao, Mark Agree Southfield MI USA ~ ~ ~

Date: Sun, 22 Jun 2008 23:07:04 -0700 From: Jay S <> To: Subject: [CR]REG pump holder on e-bay

What brand or type of pump would this holder work with? I can understand the round top piece, but the bottom piece (I'm guessing it's the bottom piece) is unusual. To my eyes, anyway.

Jay Sexton Sebastopol, CA ------------------------------

**************Gas prices getting you down? Search AOL Autos for fuel-efficient used cars. (