Many tires may fit :snug" and have a low spot when the bead doesn't want to
position itself correctly.
While working as an inspector a the old chicago schwinn plant in the '50's,
the assmbly line wheel & tire men had a brush and bottle of soap water which
was very slippery when applied to the rim and the tire pressed over.
When the hose pressure was applied, the tire almost always popped into place
and rapid piece work was posible.
We used liquid detergent in our shop and inflated tire with soap beteeen
tire and rim so the obstreperous spot would assume the position sometimes
with pressure alone or maybe the tire plier or giving it the 'ol palm and
finger treatment.
Give mit a shmier and sqveeze, baby, and zee vot happins!
Every once in a while the guys wouldn't watch the bead and if it wasn't in
the rim it would blowup, and off so fast with a loud boom or po!!
Then the whole damn area would be full of the inside tube talcum powder, if
you were too close you could speak but not hear for a minute or so and
everyone within a yard or two would be full of tacum dust!
Were we having fun or what?
Ted Ernst
Palos Verdes Estates
CA USA
I just purchased a c1960 Gitane with 650b wheels/rims. I replaced the tires, purchasing (from Harris Cyclery) a pair of new Panaracer 650b tires. However, they don't seem to set right in the rims, specially the rear (I don't think the front rim is a problem). The rear rim is a steel Rigida 650b rim (at least that's what's stamped into it). The problem is that the bead of the tire doesn't seem to want to fit all the way around: It almost appears a bit small for the wheel. What is the problem here? What is the fix? Can I "stretch" the bead at all?
It all appears to be right, but just doesn't fit that way, even when inflated, it creates a "bump" (low) in the tire, but the rim is true (no hops).
Stephan Andranian Costa Mesa, California USA http://www.GitaneUSA.com
_____________________________________
This E-mail is covered by the Electronic Communications Privacy Act, 18 U.S.C. ยงยง 2510-2521 and is legally privileged. This information is confidential information and is intended only for the use of the individual or entity named above. If the reader of this message is not the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited.