Re: [CR] How critical is 1mm in spoke length for a wheel build? - correction

(Example: Production Builders:Peugeot:PY-10)

Date: Wed, 11 Nov 2009 18:19:54 +0100
From: "Hans Joergensen" <haj@nathue.dk>
To: Eric Acuna <moschika@gmail.com>
References: <247A0B4E-2B88-4C9D-AE6A-AE418C8A036B@gmail.com>
In-Reply-To: <247A0B4E-2B88-4C9D-AE6A-AE418C8A036B@gmail.com>
Cc: Classicrendezvous@bikelist.org
Subject: Re: [CR] How critical is 1mm in spoke length for a wheel build? - correction


On 11-Nov-2009, Eric Acuna wrote:
> I wrote
> Eric Acuna wrote:
>> I'm looking to lace up some Normandy HF hubs with a 5 sp. freewheel,
>> for an early 70's Peugeot, to a set of Mavic ModE2 700c clincher rims.
>> Using a couple online spoke calculators, I get 293.3mm for the front
>> and 293.9mm non-drive side rear, and 292.1mm drive side rear.
>>
>> would a 292/293 mix like this http://tinyurl.com/ylohxun , ebay
>> #110445414676 work for this wheel build? or do i need to get 294's?
>>
>> thanks.
>> Eric Acuna
>> Santa Rosa, CA, USA
> the drive-side rear was 291.9, NOT 292.1, not sure if that makes a
> difference.

That should be no problem at all....

// Hans