Re: [CR] TA Chain Ring Nut Wrench ?

(Example: Framebuilding:Norris Lockley)

From: "Andrew R Stewart" <onetenth@earthlink.net>
To: "r cielec" <teaat4p@yahoo.com>, "Classic Rendezvous" <classicrendezvous@bikelist.org>
References: <753713.62887.qm@web53602.mail.re2.yahoo.com>
In-Reply-To: <753713.62887.qm@web53602.mail.re2.yahoo.com>
Date: Sun, 4 Apr 2010 22:11:47 -0400
Subject: Re: [CR] TA Chain Ring Nut Wrench ?

Richard- Could you grind off the centering point on the Shimano type? I'm far from the TA expert but are the chain ring bolts the same size as Campy et al?

----- Original Message -----
From: r cielec
To: Classic Rendezvous
Sent: Sunday, April 04, 2010 9:11 PM
Subject: [CR] TA Chain Ring Nut Wrench ?

Ahoy ! I have just realized the need of a two-tine wrench to fit the chain ring nuts for a TA three-arm crank. The bolts are solid and do not permit use of a Shimano type wrench having a center locating pin. Is such a wrench available? Any suggestions other than taking screwdriver to the grinding wheel? I'd like to think there is general tool for this type of slotted nut.

Thanks.

Richard Cielec Chicago, Illinois; U.S.A.

_______________________________________________

Andrew R Stewart
Rochester, NY